May 20 2004, 07:07 PM
Post
#1
|
|
|
Person of Wisdom ![]() ![]() ![]() Group: Members Posts: 142 Joined: 14-March 04 From: peoria Member No.: 258 |
as some know i bought AWD DSM's tranny and put in in my car....started it up and it wont go into 1st or reverse....just grinds....so if it goes into the other gears, then its prolly not a problem with the clutch being adjusted is it?
-------------------- Stupid White Kid Racing
Run your car, not your mouth.... |
|
|
|
![]() |
May 20 2004, 08:07 PM
Post
#2
|
|
|
Post Master ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 774 Joined: 28-October 02 From: Pekin Member No.: 32 |
A lot of times, the tranny will be very difficult to get into gear after rebuild/replacement. Drive it a bit, just to run it through the gears, see if that helps. Josh at Slo-Pny had issues getting into 1/R at first on a recent rebuild, but after a couple of minutes of driving, it was fine.
-------------------- 2009 Scion Tc
1994 Del Sol Si 1991 Talon TSi AWD 1990 Mustang GT FOR SALE!!! |
|
|
|
awd4me new tranny May 20 2004, 07:07 PM
Justincredible why are u starting a new thread with the same ques... May 20 2004, 07:59 PM
AWD DSM 1 Also check the shifter cable adjustment... I thin... May 20 2004, 08:14 PM
awd4me do they have a shifter cable adj. post on vfaq? May 20 2004, 08:53 PM
Taxiwardance QUOTE My brother's got a good tranny for sale.... May 20 2004, 09:29 PM
awd4kicks Shifter adjustment is right at the base of the shi... May 21 2004, 09:18 AM
awd4me do you think that could be the problem? when i s... May 21 2004, 02:51 PM
Justincredible yes. it sounds like the clutch is not fully engag... May 21 2004, 03:19 PM![]() ![]() |
| Lo-Fi Version | Time is now: 19th December 2025 - 02:39 PM |