![]() |
![]() |
![]()
Post
#1
|
|
![]() Post Master ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 658 Joined: 7-October 03 From: Pekin Member No.: 181 ![]() |
So, I noticed I was getting a clicking noise from my driver front axle when turning and slowing down. I think ok axle is going bad. Check it out. The CV boot has slipped off of the halfshaft end. No rips or tears in it Just slipped off the end.
any suggestions on how I go about fixing this? |
|
|
![]() |
![]()
Post
#2
|
|
![]() DSMCentral Freak ![]() ![]() ![]() ![]() Group: Members Posts: 355 Joined: 6-January 04 From: Peoria Member No.: 221 ![]() |
the shafts are around 110 including a 50 core, but the boot is only like 20 but the labor is about the same unless you are a do it yourselfer
i need new cv halfshafts cuz when that downpoor came down the parking lot was flooded up to my bumpers for about 2 hours, and now i think the cv boots are shot and the joints are dry -------------------- Dodge Neon SRT-4
Electric Blue Pearl Mopar true cold air intake Mopar cat-delete downpipe Borla exhaust Hard intercooler pipes Tokico illumina springs and struts Tinted front and rear windows ASA ten spokes with crome lip 17inch Michelin Piliot Exaltos 205-50-zr17 |
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 14th October 2025 - 12:04 PM |