Testing Waters 91 TSi AWD Options

[mark95turbo]

$2600 as it sits!

-Evo III 16G
-Hacked Intake with K&N
-ACT 2600 Pressure Plate
-ACT full face organic Clutch Disc
-No name brand Manual MBC
-6-bolt block
-Bottom end has under 40K on it
-Top end is freshly cast with 20K on it
-New OEM copper headgasket
-The engine yields 160-170 PSI across the board
-Transmission I just put in along with the x-fer case and it shifts good
-Slightly ported EVO III O2 housing
-Custom mandrel bent 3" exhaust from the O2 housing to the rear axle where it turns to 2.5" and goes into a magnaflow muffler
-SAFC II
-Walbro 255 LPH fuel pump
-Autometer phantom boost gauge
-New tie rod ends
-Stock wheels with brand new Falken Ziex 512 Z rated tires
-APR head studs
-New head gasket
-New T-belt tensioner (t-belt was in great shape when I replaced the tensioner)
-Suspension is stock
-interior is halfway gutted
-4 bolt rear end
-Stock intercooler with stock pipes and crushed 1st gen BOV
-Custom sheet metal airbox that completely blocks the intake from underhood
-EGR blocked off
-Stock stereo
-Balance shafts removed

Clutch seems to have some binding. It doesnt like to go into gear but it does and the RPM's drop and make a whirring noise when you push the clutch in. I'm pretty sure its either the Throw out bearing or the clutch disc. I have an entire stock clutch assembly that I would include with the car along with anything else that I have that goes with a DSM including all of the interior. Car runs great aside from the clutch I just dont feel like pulling the tranny for the 4th time in 7 months so my loss is your gain! I just dumped 2K into this car after paying $2700 for it initially less than a year ago and putting less than 6K on it in that year!

[dancomer]

well if you change your mind it is a red but is now black si 5 speed with a single cam ZC jdm engine and it has about 38K miles, tokico struts and shocks, ground control coilovers, integra seats in the front from a 91, it comes with a fiberglass hood, it has energy suspension bushings all round, it has projector head lights but the glass on them is gone, it now has a manual steering rack but the power steering pump and lines are included, it comes with 2 LS rims, and a set of slicks for 13" rims, it comes with a tenzo R exhaust, and a full 3 inch exhaust, it comes with a turbo kit that is not on the car currently, comes with a front mount and the fual computer piggy back system, it somes with the header, piping that needs work, front and rear strut tower bars, the car needs some body work, but some of that may be taken care of before you come and look at it or whatever.... the rear 1/4 on the pass. side has a dent but my friend and i are going to weld a new pice of sheet metal in...the sunroof has cracked glass but was covered with vinyl so it does not leak....the car runs like a champ and gets great gasmialage....give me a call at 847-456-7553 and you can come and take a look at it or if you want i might be able to come to you....but let me know what you think...i am ausre that there is more stuff but i don't remember...but i am looking to get 4000 out of it...or a AWD talon...so let me know