 mat translator, ? |
 Sep 25 2004, 06:58 PM
Post
#1
|
|
 Beginner  Group: Members Posts: 48 Joined: 10-May 04 Member No.: 293  |
i just purchased a maf-t is there a connector or anything i need for it to hook up to 1g? also i wanted to know what parts i needed to run a blow though set up to vent the blow off valve to the atmosphere
|
 |
 
|
 |
Replies
|
Sep 25 2004, 09:55 PM
Post
#2
|
|
 DSMCentral Freak Group: Members Posts: 388 Joined: 2-January 03 From: Peoria Heights Member No.: 59 |
To bad I didn’t see this earlier I just sold my supra side mount and Blow Thu IC setup. If you want to run the MAF and be able to vent you will need an upper pipe that will allow you to move the GM MAF past the BOV. Mine cost 200 from dejontool but there are a few different setups out there. None of them cheap. You might want to look at a draw thu setup to save you a few headaches. Also the pipe I had placed the BOV right on top of the filter which made me have to cut the hell out of my intake pipe and suck up lots of hot air!
|
|
|
|
Posts in this topic
all_wheel_envy mat translator Sep 25 2004, 06:58 PM
turbohcar well....did you just purchase the GM MAF or did yo... Sep 25 2004, 07:40 PM DSM5 Dejon tool sells pipes that work for your blow thr... Sep 25 2004, 09:50 PM ICGerms QUOTE (Taxiwardance @ Sep 25 2004, 09:55 PM).... Sep 25 2004, 10:06 PM SCCA Stang also remember that you need to have the 1G transla... Sep 26 2004, 12:31 PM all_wheel_envy ok cool ill havr to find out what one its for but ... Sep 26 2004, 09:34 PM
Justincredible you need a 1g maf trans and a 3 or 3.5 inch gm maf... Sep 27 2004, 09:29 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 9th October 2025 - 07:16 AM |
Powered By IP.Board
© 2025 IPS, Inc.