 mat translator, ? |
 Sep 25 2004, 06:58 PM
Post
#1
|
|
 Beginner  Group: Members Posts: 48 Joined: 10-May 04 Member No.: 293  |
i just purchased a maf-t is there a connector or anything i need for it to hook up to 1g? also i wanted to know what parts i needed to run a blow though set up to vent the blow off valve to the atmosphere
|
 |
 
|
 |
Replies
|
Sep 25 2004, 10:06 PM
Post
#2
|
|
|
Person of Wisdom Group: Members Posts: 227 Joined: 4-February 03 From: IA Member No.: 78 |
QUOTE (Taxiwardance @ Sep 25 2004, 09:55 PM) ...Mine cost 200 from dejontool but there are a few different setups out there. None of them cheap. You might want to look at a draw thu setup to save you a few headaches.... If you can weld at all (or know someone who can) you can easily make one yourself. Get mandrel bent piping from JCWhitney and the flanges and gaskets from RRE and make a custom setup for yourself. I've done a couple myself and have only moderate (at best) welding skills. -------------------- '90 Talon TSi AWD
300 awhp _________________ ...here's your sign... |
|
|
|
Posts in this topic
all_wheel_envy mat translator Sep 25 2004, 06:58 PM
turbohcar well....did you just purchase the GM MAF or did yo... Sep 25 2004, 07:40 PM DSM5 Dejon tool sells pipes that work for your blow thr... Sep 25 2004, 09:50 PM Taxiwardance To bad I didn’t see this earlier I just sold my su... Sep 25 2004, 09:55 PM SCCA Stang also remember that you need to have the 1G transla... Sep 26 2004, 12:31 PM all_wheel_envy ok cool ill havr to find out what one its for but ... Sep 26 2004, 09:34 PM
Justincredible you need a 1g maf trans and a 3 or 3.5 inch gm maf... Sep 27 2004, 09:29 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 4th December 2025 - 02:21 PM |
Powered By IP.Board
© 2025 IPS, Inc.