 Need Help with 1st gen that has no power, my laser turbo won't stay running |
  May 24 2005, 08:18 PM
Post
#1
|
|
|
Newbie Group: Members Posts: 2 Joined: 21-May 05 Member No.: 525  |
I have a 1991 laser turbo that is all stock, it revs up and down when you start it and then after a while just dies. When you put it in gear the cars moves slow and wont rev up at all. It throws up codes for the intake air temp sensor, TPS sensor, and other sensors. I checked the TPS sensor and it was fine. I thought the problem might be fuel related but I can't find anything wrong. Hopefully someone might know a common problem these have.
|
 |
 
|
 |
Replies
|
Jun 20 2005, 10:01 PM
Post
#2
|
|
|
Newbie Group: Members Posts: 2 Joined: 21-May 05 Member No.: 525 |
I have tried about everything. I took off the throttlebody, cleaned it all out, put a new o-ring on the biss screw, blocked off the Egr valve, and beat out the catylitic converter. All this did was steady the idle and make it run a little better, but the car still has no power in drive. I unhooked the fuel rail and checked the fuel pressure right out of the fuel filter, it was 60psi to begin with then built up to 70psi. I think problem is the fuel pressure regulator, but not sure if that would make my car do this.
|
|
|
|
Posts in this topic
dayton2525 Need Help with 1st gen that has no power May 24 2005, 08:18 PM
MidwestDSM here May 24 2005, 09:16 PM The Iron Goat QUOTE (dayton2525 @ May 24 2005, 08:18 PM)Hop... May 25 2005, 08:25 AM Cyclone93 have u checked ur fuel pressure? It could be the f... Jun 10 2005, 07:32 PM natedogg You should check your fuel pressure with the rail ... Jun 21 2005, 10:14 AM
black92_tsi_awd Yeah, your deadheading the pump. The pressure wil... Jun 21 2005, 11:15 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 8th August 2026 - 05:23 PM |
Powered By IP.Board
© 2026 IPS, Inc.