 Engine Q. |
 Nov 22 2005, 01:32 PM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636  |
Ok, I know this is a stupid question. But I don't know the answer.
Here goes I am working on Fireball and I need to figure out a way to get it to turn over. Now to remind all of you, it does not have any fuses or a fuse block under the hood or dash. So is there a way I can just get it to turn over with the battery hooked up? Now this is without me getting the shizzle shocked out of me also,  !Thanks guys for any input. BTW- I am wanting to do a compression check on her. -------------------- Thanks, Bud!
 |
 |
 
|
 |
Replies
|
Nov 22 2005, 01:37 PM
Post
#2
|
|
|
DSM Tech Wizard Group: Members Posts: 2,404 Joined: 16-December 03 From: Fletcher/Bloomington Member No.: 214 |
Tools needed:
1/2 inch breaker bar tire changing tools Procedure: Jack up the front of the car Take the drivers side wheel off stick the breaker bar in the square key in the middle of the crankshaft pulley rotate clockwise Then you'll be able to tell if that motor is locked up or not. If you're wanting it to run, I don't think it's possible without the fuse blocks. Not sure if this helps you with your compression test or not. -------------------- "I hear he tunes the space shuttle also...and that thing is fast"
|
|
|
|
Posts in this topic
BudmannG Engine Q. Nov 22 2005, 01:32 PM
awdnot2 You'll need to apply power to the starter sole... Nov 22 2005, 01:42 PM eclipgst Procedure:
Get a Glock .45
Put a bullet in the c... Nov 22 2005, 02:33 PM
99Spyder Quick and dirty?
Assuming that the wire from the b... Nov 23 2005, 07:20 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 16th March 2026 - 05:49 AM |
Powered By IP.Board
© 2026 IPS, Inc.