 Engine Q. |
 Nov 22 2005, 01:32 PM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636  |
Ok, I know this is a stupid question. But I don't know the answer.
Here goes I am working on Fireball and I need to figure out a way to get it to turn over. Now to remind all of you, it does not have any fuses or a fuse block under the hood or dash. So is there a way I can just get it to turn over with the battery hooked up? Now this is without me getting the shizzle shocked out of me also,  !Thanks guys for any input. BTW- I am wanting to do a compression check on her. -------------------- Thanks, Bud!
 |
 |
 
|
 |
Replies
|
Nov 22 2005, 01:42 PM
Post
#2
|
|
 DSMCentral Freak Group: Members Posts: 396 Joined: 10-January 01 From: Peoria, IL Member No.: 8 |
You'll need to apply power to the starter solenoid. You can do that running a small wire from the battery and touching to the spade connector on the solenoid. You will get a spart or two. Ideally you want a switch momentary switch inline with the proper capacity.
-------------------- |
|
|
|
Posts in this topic
BudmannG Engine Q. Nov 22 2005, 01:32 PM
turbohcar Tools needed:
1/2 inch breaker bar
tire changing t... Nov 22 2005, 01:37 PM eclipgst Procedure:
Get a Glock .45
Put a bullet in the c... Nov 22 2005, 02:33 PM
99Spyder Quick and dirty?
Assuming that the wire from the b... Nov 23 2005, 07:20 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 16th March 2026 - 05:49 AM |
Powered By IP.Board
© 2026 IPS, Inc.