 Compressor surge? |
 Jul 5 2006, 09:13 PM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636  |
What would case compressor surge?
I have gotten many answers. I was told it was because my bov is to tight? I have a rfl bov. I did not recieve said spring adjusting washers. So what would I use in place of these washers? I am at wits end with this thing. I try to pull a wot and when I hit 12psi it burps out the turbo and then I get boost spikes up to 20 psi. -------------------- Thanks, Bud!
 |
 |
 
|
 |
Replies
|
Jul 7 2006, 07:13 PM
Post
#2
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636 |
Alright!! I cut off three rings. Now I can pull hard in 1st and 2nd without surge. But, My boost gauge goes up to 22-24psi . Just bouncing like a jumping bean. When I hit third and start to pull hard it does it's dance on me again.
But wow what a difference those three rings made. I have no control over my mbc. It is turned all the way out, which is less boost, right? I will have to look again. But it don't boost over 24 psi right now. Just so you know my vacuume line from the intake is hooked to the bottom. And the outlet to the wastegate is hooked to the side. Is this correct? It is a hallman boost controller. -------------------- Thanks, Bud!
|
|
|
|
Posts in this topic
BudmannG Compressor surge? Jul 5 2006, 09:13 PM
BudmannG I have had to make my own washers to put in this B... Jul 7 2006, 05:56 AM BudmannG QUOTE (spyonu2007 @ Jul 7 2006, 09:19 AM)Bud,... Jul 7 2006, 03:02 PM BudmannG I think that I found my problem.
I went out to ta... Jul 7 2006, 05:33 PM turbohcar Compressor surge is not caused by a turbo with too... Jul 7 2006, 06:20 PM AWD DSM 1 QUOTE (turbohcar @ Jul 7 2006, 06:20 PM)Compr... Jul 7 2006, 06:22 PM BudmannG I will go hack them up right now!!! So... Jul 7 2006, 06:26 PM 99Spyder I am not an expert on either shaft play (I know so... Jul 7 2006, 06:32 PM 99Spyder Yep, just checked the Hallman site and the boost s... Jul 7 2006, 08:06 PM BudmannG OK, That problem is solved, I have it hooked up ri... Jul 7 2006, 08:25 PM 99Spyder Well let's see... the Hallman has an internal ... Jul 7 2006, 11:44 PM
turbohcar If you've got really sloppy shaft play that my... Jul 8 2006, 04:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 25th September 2026 - 06:16 AM |
Powered By IP.Board
© 2026 IPS, Inc.