 Compressor surge? |
 Jul 5 2006, 09:13 PM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636  |
What would case compressor surge?
I have gotten many answers. I was told it was because my bov is to tight? I have a rfl bov. I did not recieve said spring adjusting washers. So what would I use in place of these washers? I am at wits end with this thing. I try to pull a wot and when I hit 12psi it burps out the turbo and then I get boost spikes up to 20 psi. -------------------- Thanks, Bud!
 |
 |
 
|
 |
Replies
|
Jul 7 2006, 08:25 PM
Post
#2
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636 |
OK, That problem is solved, I have it hooked up right.
Now why can I not get my boost to go down? I really don't want to run 22-24psi all the time. I did check the valve on the mbc and it says out to lower boost and in to up the boost. It is turned all the way out for the lower boost. I have it turned out so far that you can here the ball and spring when you shake it. -------------------- Thanks, Bud!
|
|
|
|
Posts in this topic
BudmannG Compressor surge? Jul 5 2006, 09:13 PM
BudmannG I have had to make my own washers to put in this B... Jul 7 2006, 05:56 AM BudmannG QUOTE (spyonu2007 @ Jul 7 2006, 09:19 AM)Bud,... Jul 7 2006, 03:02 PM BudmannG I think that I found my problem.
I went out to ta... Jul 7 2006, 05:33 PM turbohcar Compressor surge is not caused by a turbo with too... Jul 7 2006, 06:20 PM AWD DSM 1 QUOTE (turbohcar @ Jul 7 2006, 06:20 PM)Compr... Jul 7 2006, 06:22 PM BudmannG I will go hack them up right now!!! So... Jul 7 2006, 06:26 PM 99Spyder I am not an expert on either shaft play (I know so... Jul 7 2006, 06:32 PM BudmannG Alright!! I cut off three rings. Now I can... Jul 7 2006, 07:13 PM 99Spyder Yep, just checked the Hallman site and the boost s... Jul 7 2006, 08:06 PM 99Spyder Well let's see... the Hallman has an internal ... Jul 7 2006, 11:44 PM
turbohcar If you've got really sloppy shaft play that my... Jul 8 2006, 04:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 29th April 2026 - 07:12 PM |
Powered By IP.Board
© 2026 IPS, Inc.