![]() |
![]() |
![]()
Post
#1
|
|
![]() Eats and sleeps DSM jargin. ![]() ![]() ![]() ![]() ![]() ![]() Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636 ![]() |
![]() ![]() I was going down this country road about 55mph. Coming up on a hill and top it. At the top of the hill it turns into gravel.And there is a S10 in the middle of the road. He don't fucking move! ![]() Well it didn't start the first 5 minutes I tried. I even had enough time to go into DSM Link and activate the fuel pump. Still didn't work, So it was time to get out of the car. I didn't even look at the damage. I just went straight to where the battery was supposed to be. The battery was in the spare tire area when I looked. I picked up the battery and put it back. I noticed that it riped the fuel pump wire off. I did a quick twist on the wires and closed the deck lid. Went back up and she started on the first try. So then I drove it home and then looked at the damage. Now while all that was going on! The guy in the S10 doesn't even turn around to see if I am ok. Didn't stop ask if I need help or anything. CAN YOU FUCKING BELIEVE THAT? This **** runs me off the road and then doesn't even stop. All I know is I was trying to save my car. Well I failed misserably at it. I tore of the passenger mirror with what I think was a tree. The drivers side rear bumper was ripped out also with what I think was a tree. The passengers side of the car got the worst of everything. I haven't raised the hood to see if I fucked anything up under there. The passenger side rear quarter panel is all smoothed down by the tree also. The rear bumper is fucked beyond repair. Now I have a car that is going to need a shit load of repairs to the body. Hell I don't even know if the thing runs straight down the road anymore. ![]() I will post pics up later of the damage! -------------------- |
|
|
![]() |
![]()
Post
#2
|
|
Web Administrator Yo! ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 516 Joined: 30-August 04 From: Mackinaw, IL Member No.: 376 ![]() |
QUARTER WINDOW GLASS ASSEMBLY REMOVAL
(1) For protection of the body (coated surface); apply cloth tape to all around the body where the glass is installed. (2) Using a cutter knife, cut off the quarter window molding along its edge. (3) Run a wire between the glass and the body at the upper portion of the quarter window and pull it back and forth along the glass to cut through the adhesive. When doing so, pay attention to the clip grommet. Caution - Hold the window glass with the glass holders to prevent it from falling when the adhesive cuts through. (4) Using a sharp knife, scoop out existing adhesive from the body flange to 2 mm (.08 in.) or less thickness all around the window opening. (5) Finish smooth the flange surface. Caution ---1. Do not remove the adhesive more than necessary. ---2. Use care not to damage the coated surface of the body with the knife. If it is damaged, apply retouch paint or anti-corrosive. (6) Degrease using with isopropyl alcohol. Caution - After degreasing, allow three minutes or more to dry well before next work. Do not touch the degreased surface. -------------------- Fast & Furious on the outside...DSM under the hood!!!
|
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 10th October 2025 - 09:05 AM |