 Full A-pillar pods for a 1st gen? |
 Jun 26 2003, 01:26 PM
Post
#1
|
|
 DSMCentral Freak  Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21  |
I'm assuming that nobody makes a full A-pillar pod for the 1st gen. I am going to try my hand at fiberglassing and was wonering if anybody would be interested in buying these full a-pillars If I could make them. I think the roughest part would be the texturing. I would of course offer a good discount to DSMcentral members.
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
 |
 
|
 |
Replies
|
Jun 26 2003, 04:03 PM
Post
#2
|
|
|
DSMCentral Freak Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21 |
I was looking at the car. I'm thinking about doing a pod that runs all the way from the dash up to the top where the seatbelt slider stops. I think it will look better than 2 or 3 pods screwed onto the stock a-pillar. Does anybody have any spare a-pillars theybe be willing to sell me for experimenting? I'de most likely make a mold and then just fiberglass into the same mold every time, so ide of course need an extra a-pillar or 2 or experimentation.
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
|
|
|
Posts in this topic
mark95turbo Full A-pillar pods for a 1st gen? Jun 26 2003, 01:26 PM
natedogg I might be interested in a single guage pod. I... Jun 26 2003, 01:42 PM AWD DSM 1 I've never found a pod for the 1g's that c... Jun 26 2003, 02:10 PM
AWD DSM 1 I've got a couple tan ones that I'd be wil... Jun 26 2003, 09:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 19th October 2025 - 06:53 AM |
Powered By IP.Board
© 2025 IPS, Inc.