 Transfer case, help! |
  Aug 14 2003, 05:07 PM
Post
#1
|
|
 DSMCentral Freak  Group: Members Posts: 388 Joined: 2-January 03 From: Peoria Heights Member No.: 59  |
Well ive got everything disconnected and the engine ready to pull exept i cant get the transfer case off???? The manual says, drain-remove 4 bolts (there was 5 on mine?) then pull to the side and remove of driveshaft. I have the bolts off but i cant disengage it from the tranny/driveshaft someone tell me what im doing wrong.
|
 |
 
|
 |
Replies
|
Aug 14 2003, 05:45 PM
Post
#2
|
|
 Post Master Group: Members Posts: 626 Joined: 25-September 02 From: Urbana, IL Member No.: 19 |
It should come off, assuming you removed the correct bolts (5 - 17mm head). If it has never been off before, its likely quite stuck, and you'll have to pry it away from the transmission. You'll want to grease the splines a little before you re-assemble it.
-------------------- Eric Wort
87 White Buick Turbo 'T' (11.71 @ 116.5, 1.61 60ft, slipping trans) 92 Teal Eagle Talon TSi AWD (burn victim) |
|
|
|
Posts in this topic
Taxiwardance Transfer case Aug 14 2003, 05:07 PM
Taxiwardance Yep i got all 5 17mm bolts, i just had the tranny ... Aug 14 2003, 07:49 PM Turbo Tension Get a lot of flat head screw drivers and start pou... Aug 14 2003, 07:57 PM Taxiwardance Engines out!!!!! and its only ... Aug 15 2003, 02:13 AM awd4kicks You can pick up new stock sway bar end links at a ... Aug 15 2003, 07:38 AM Taxiwardance yep it was a bearing. It was my front balance shaf... Aug 15 2003, 07:58 AM AWD DSM 1 If it's just a balance shaft, you might be abl... Aug 15 2003, 09:02 AM JBone QUOTE (POS AWD @ Aug 15 2003, 09:02 AM)I gues... Aug 15 2003, 11:51 AM
KOU In3 QUOTE (Taxiwardance @ Aug 15 2003, 08:13 AM)E... Aug 15 2003, 01:56 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 16th June 2026 - 08:40 PM |
Powered By IP.Board
© 2026 IPS, Inc.