 Shift linkage trouble!?!?!?, no 5th or reverse! |
 Oct 3 2003, 05:22 PM
Post
#1
|
|
 DSMCentral Freak  Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21  |
Well I finally got off of my ass and got the TSi back together but now I seem to have no 5th or reverse. I'm assuming that this has to do with the shift linkage somewhere, but I've looked it over about 1000 times and I cant figure it out. I just installed an ACT 2600# pressure plate and an ACT full face disc. Also, when the car is in gear it moves around a ton and it used to be nice and tight before this project. Any suggestions? Is it my linkage or did I screw the tranny up somehow? I havnt driven the car yet, or let the clutch engage totally as its in the garage and I havnt pushed it out to take it for a drive, but after I do I will post if there are any changes. Thanks guys!
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
 |
 
|
 |
Replies
|
Oct 4 2003, 09:56 AM
Post
#2
|
|
 Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
Pulling the shifter is easy. Unattach the cables (clips and pins), unscrew the 4 bolts that hold it down and you're done. The linkage is pretty easy to replace as well. One nut holds it to the floor behind the ECU. Two bolts hold it to the fire-wall. Then disconnect it from the transmission and pull it through.
|
|
|
|
Posts in this topic
mark95turbo Shift linkage trouble!?!?!? Oct 3 2003, 05:22 PM
mark95turbo Also, if you know what the trouble is and you read... Oct 3 2003, 05:23 PM mark95turbo N\M it is the plastic sleve that goes around ... Oct 3 2003, 08:31 PM KOU In3 Are you talking about the transmission brackets th... Oct 4 2003, 12:00 AM
mark95turbo No, I mean the bracket that is attached to the tra... Oct 4 2003, 03:11 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 21st June 2026 - 12:21 PM |
Powered By IP.Board
© 2026 IPS, Inc.