 More tranny questions, Yes, a DSM with a screwy tranny:) |
 Jan 12 2004, 12:30 PM
Post
#1
|
|
 DSMCentral Freak  Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21  |
OK. So im stumped. My transmission goes into 1st 3rd and 5th just fine, but 2nd, I have to put it into gear(or what should be in gear as far as the shifter's position, then wiggle it a bit and I feel it pop into place. Same goes for 4th and reverse is almost impossible. When I move the shifter to where its supposed to be in gear, I feel a bit of resistance as if something were stretching. I thought maybe the cables were binding but I checked all of the cables and they are fine. I'm almost positive its a problem with not the tranny itsself, but rather something before the cables meet the transmission because if I mive the levers on the outside of the transmission by hand, it goes into gear just fine. WTF? Do I need new cables? I'm stumped! Oh yeah, if I granny shift its usually ok, but shifting at higher RPM's is a no go. Also, when the car is at a dead stop, or turned off it goes into 2nd and 4th fine. TIA!
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
 |
 
|
 |
Replies
|
Jan 14 2004, 05:17 PM
Post
#2
|
|
|
DSMCentral Freak Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21 |
How much did new cables run you? Also, what are you opinions on the welded center diff? I've been thinking about getting the one that TRE sells. Right now, im looking at about $650 worth of tranny stuff for the rebuild.
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
|
|
|
Posts in this topic
mark95turbo More tranny questions Jan 12 2004, 12:30 PM
natedogg Sounds kinda like what would happen with my tranny... Jan 12 2004, 01:19 PM mark95turbo Thats kinda what I was thinking because it first h... Jan 12 2004, 03:12 PM natedogg Yeah, I went with the steel Evo III shift forks fr... Jan 13 2004, 08:38 AM mark95turbo OK. I messed with it a bit again last nite and I ... Jan 14 2004, 11:28 AM natedogg Did you check the cable right at the shifter? The... Jan 14 2004, 11:38 AM
natedogg For a race car I think a welded center diff isn... Jan 15 2004, 09:26 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 10th August 2026 - 03:53 PM |
Powered By IP.Board
© 2026 IPS, Inc.