 Quick question |
  |
 Jun 5 2005, 03:02 PM
Post
#1
|
|
 Post Master  Group: Members Posts: 780 Joined: 14-July 04 Member No.: 338  |
I think I may have a boost leak. The car has been running extremely weird since I've been in Texas. That long ride must have pissed the car off. Anyhow, at higher rpms (mid to WOT), the car starts bucking like hell. Sounds like the car's choking on fuel. And now I've noticed that I can punch the throttle, but the car doesn't go like it should. Also, the turbo spools up fully, so I'm pretty sure it's a boost leak. I can't find any obvious area that is leaking, so any common areas that it may be leaking that you boys know of?
-------------------- QUOTE (gsxracer80 @ Oct 31 2006, 12:41 AM)
thanks hcar.... I am still massaging that area trying to get it ready...  |
 |
 
|
|
Jun 5 2005, 03:14 PM
Post
#2
|
|
|
Web Administrator Yo! Group: Admin Posts: 516 Joined: 30-August 04 From: Mackinaw, IL Member No.: 376 |
Definatley sounds like a boost leak. Throttlebody leaks are common but yours sounds like it holds until a certain psi. I would check the couplers on the IC piping first.
-------------------- Fast & Furious on the outside...DSM under the hood!!!
|
|
|
|
|
Jun 5 2005, 07:03 PM
Post
#3
|
|
|
Post Master Group: Members Posts: 780 Joined: 14-July 04 Member No.: 338 |
I'm assuming that some resin on the IC endtanks would be in order as well? Good measure and all?
-------------------- QUOTE (gsxracer80 @ Oct 31 2006, 12:41 AM)
thanks hcar.... I am still massaging that area trying to get it ready... |
|
|
|
|
Jun 6 2005, 06:55 AM
Post
#4
|
|
 Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
If you have access to an air compressor, you could try a boost leak test. All you need is a valve stem, pvc pipe cap, and a fernco plumbing fitting to fit the turbo intake. This will pressurize the intake system and you can listen for leaks. I just did this again a few days ago and found 2 small leaks at my throttle body.
I ended up needing a new gasket and new tb shaft seals. |
|
|
|
|
Jun 6 2005, 07:06 AM
Post
#5
|
|
 Post Master Group: Members Posts: 986 Joined: 7-July 04 From: Central Illinois Member No.: 318 |
"listening" for leaks? Is a light mix of dishwashing soap and water recommended much like a natural gas fitting leak test ... ?
-------------------- ... she likes bein' forced ...
|
|
|
|
|
Jun 6 2005, 07:10 AM
Post
#6
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
You can usually hear the leak(s) just fine. Then you can run your hand around the general area that you hear the leak from and feel where the air is coming from.
Since you're still in the area Kazz, you're more than welcome to come over sometime to check for boost leaks on your car. I have a boost leak tester that will fit your turbo. I'd like to run a check on my Evo also. I've only done the nugget. |
|
|
|
|
Jun 6 2005, 07:48 AM
Post
#7
|
|
|
DSMCentral Freak Group: Members Posts: 291 Joined: 14-July 04 Member No.: 339 |
Do you know if you can check the S4 sometime? I have no boost right now....
|
|
|
|
|
Jun 6 2005, 08:44 AM
Post
#8
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
Sure. I'll be working in the garage tomorrow night if you want to stop by. PM me for directions.
|
|
|
|
|
Jun 6 2005, 11:48 AM
Post
#9
|
|
|
Post Master Group: Members Posts: 986 Joined: 7-July 04 From: Central Illinois Member No.: 318 |
Tuesday night boost leak party? *Laugh*
When's it start and what can I bring? -------------------- ... she likes bein' forced ...
|
|
|
|
|
Jun 6 2005, 12:07 PM
Post
#10
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
Anytime after 5 is fine. Some cold beer is always welcome.
|
|
|
|
|
Jun 6 2005, 04:00 PM
Post
#11
|
|
|
Post Master Group: Members Posts: 986 Joined: 7-July 04 From: Central Illinois Member No.: 318 |
PM me the flavor and I'll see if I can be there...
-------------------- ... she likes bein' forced ...
|
|
|
|
|
Jun 7 2005, 10:49 PM
Post
#12
|
|
|
Post Master Group: Members Posts: 986 Joined: 7-July 04 From: Central Illinois Member No.: 318 |
Props to natedogg - leaky BOV identified. Now the dilemna of how to replace it. That JDM MR BOV is tasty ... but how practical is any other replacement for God's sake? It's just a BOV(BPV) ...
-------------------- ... she likes bein' forced ...
|
|
|
|
|
Jun 8 2005, 12:28 AM
Post
#13
|
|
|
DSMCentral Freak Group: Members Posts: 291 Joined: 14-July 04 Member No.: 339 |
i also have to give props to nate. He helped me out alot today!
Although on the downside, i think my turbos are blown 
|
|
|
|
|
Jun 8 2005, 01:19 AM
Post
#14
|
|
 Post Master Group: Members Posts: 810 Joined: 9-July 03 From: Bloomington, IL Member No.: 151 |
big ouch man...sounds like its time for an upgrade!
|
|
|
|
|
Jun 8 2005, 06:51 AM
Post
#15
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
Glad to help, guys.
|
|
|
|
|
Jun 8 2005, 07:47 AM
Post
#16
|
|
|
DSMCentral Freak Group: Members Posts: 291 Joined: 14-July 04 Member No.: 339 |
oh, people are telling me my cars smoking because we didnt block off the pcv valve or something. I have to go let my idle for 20 minutes and see if the smokes stop.
|
|
|
|
|
Jun 8 2005, 10:31 AM
Post
#17
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
Hmm...European cars are wierd...
|
|
|
|
|
Jun 8 2005, 01:43 PM
Post
#18
|
|
|
DSMCentral Freak Group: Members Posts: 291 Joined: 14-July 04 Member No.: 339 |
no kidding! But on the bright side, the smokes basically all cleared up (the turbo's arent dead yet!). I ordered some BPV's, so hopefully that fixes the problem. If not i'm going to be VERY confused!
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 16th June 2026 - 12:48 AM |
Powered By IP.Board
© 2026 IPS, Inc.