 ball joint |
  |
 Nov 18 2006, 08:12 PM
Post
#1
|
|
|
Info Seeker  Group: Posts: 75 Joined: 24-January 06 Member No.: 786  |
anyone have any tips on how to get the ball joints out of the control arm. i cant really tell where the ball joint ends and where the control arm starts. im not sure wich way youre suposed to beat it out the top or bottom. im assuming the bottom. any little extras that anyone might have would be greatly appreciated. thanks.
|
 |
 
|
|
Nov 19 2006, 11:45 AM
Post
#2
|
|
|
DSMCentral Godfather Group: Admin Posts: 3,823 Joined: 10-January 01 From: Washburn Member No.: 26 |
If I remember right I have only pressed them out. So that means you have to push them out from one side. I've got a press you can use, but it's all the way up in here Washburn.
-------------------- In Loving memory of David T Crebo
Greatness comes from the most unexpected places!  |
|
|
|
|
Nov 19 2006, 12:39 PM
Post
#3
|
|
|
Person of Wisdom Group: Members Posts: 173 Joined: 22-December 04 From: Bloomington Member No.: 399 |
Pickle Fork... But be carefull not to cut the rubber.
|
|
|
|
|
Nov 19 2006, 05:15 PM
Post
#4
|
|
|
Info Seeker Group: Posts: 75 Joined: 24-January 06 Member No.: 786 |
i got one out today. i was cutting away at the rubber boot and realized there is a retaining ring on them. i got the ring off and put some heat to it and hit it a few times and it popped right out of there. not near as hard as i thought it would be.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 10th October 2025 - 09:56 AM |
Powered By IP.Board
© 2025 IPS, Inc.