Jul 29 2003, 02:11 AM
Post
#1
|
|
|
DSMCentral Freak ![]() ![]() ![]() ![]() Group: Members Posts: 256 Joined: 30-October 02 From: Chicago Member No.: 33 |
aright guys, here is the situation:
the car doesn't want to go in gear when its started. no gears, it refuses to go. if I shut the car off, I can put it in gear. If I start the car while it is in gear, the car just starts moving as soon as I crank the motor even though the clutch is depressed. I just installed the bm lsd insert and a act 2100 with a resurfaced flywheel. We filled the tranny with 2.5 quarts of pennzoil syncromesh aka gm syncromesh. During the install, we had a HARD time with the slave cylinder installation. It was just a tight fit. Yea I know its not supposed to be a biggie, but it was. Im thinking maybe the problem is either the slave cylinder or the throw out bearing. when I press the clutch, I can see the lever move. During the install, I made sure the rod didn't come out all the way, so that I wouldn't have to bleed the clutch system. I think out of the two its most likely the throwout bearing. What do you guys think? |
|
|
|
NOMIEZVR4 installed new clutch...BIG problem..please help. Jul 29 2003, 02:11 AM
AWD DSM 1 A lot of guys have problems with the length of the... Jul 29 2003, 05:33 AM
natedogg There are a few cheap tricks you can try. Like Ro... Jul 29 2003, 07:44 AM
NOMIEZVR4 ive done some searching and ive found other possib... Jul 29 2003, 11:05 AM
wortdog I never noticed a difference with a longer slave c... Jul 29 2003, 11:39 AM
KOU In3 If either of you want the clutch pedal assembly fr... Jul 29 2003, 08:52 PM
NOMIEZVR4 Hey KOU, sent ya a pm. Jul 29 2003, 10:44 PM![]() ![]() |
| Lo-Fi Version | Time is now: 18th November 2026 - 09:58 AM |