 transfer case |
  |
 May 9 2005, 11:56 AM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314  |
well I locked up my TC the other day and took it to the dealer, got a call from them today and they say it is going to cost me $2700
 they said it's not covered under the recall because it has already been done in 1998. my question it what do I do to get them to fix this?
-------------------- ┌∩┐(◣_◢)┌∩┐
 |
 |
 
|
|
May 9 2005, 02:20 PM
Post
#2
|
|
 Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
I'd check a vehicle history report or something similar to see if the recall has actually been done or if they're lying to you. If it has already been done, I'd look for a used transfer case and swap it yourself.
|
|
|
|
|
May 9 2005, 02:48 PM
Post
#3
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
they called back and said that it was full of fluid and showed no sines of leaking and it was internal failure.
I need to trailer the car from the dealer to green valley anyone want to lend me a trailer? also in need of a good used auto TC if anyone has one ? -------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 9 2005, 02:50 PM
Post
#4
|
|
 Post Master Group: Members Posts: 626 Joined: 25-September 02 From: Urbana, IL Member No.: 19 |
Transfer case recall is good for life. I think the dealer actually replaced Netter's whole transmission for free when his transfer case melted.
Some phone numbers to try: http://www.dsmtuners.com/forums/showthread.php?t=19280 -------------------- Eric Wort
87 White Buick Turbo 'T' (11.71 @ 116.5, 1.61 60ft, slipping trans) 92 Teal Eagle Talon TSi AWD (burn victim) |
|
|
|
|
May 9 2005, 03:03 PM
Post
#5
|
|
|
Post Master Group: Members Posts: 626 Joined: 25-September 02 From: Urbana, IL Member No.: 19 |
QUOTE (mitsu90 @ May 9 2005, 08:48 PM) they called back and said that it was full of fluid and showed no sines of leaking and it was internal failure. Too bad you didn't check the fluid level first to make sure they didn't just fill it up after the fact. -------------------- Eric Wort
87 White Buick Turbo 'T' (11.71 @ 116.5, 1.61 60ft, slipping trans) 92 Teal Eagle Talon TSi AWD (burn victim) |
|
|
|
|
May 9 2005, 03:14 PM
Post
#6
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
I thought the same thing
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 10 2005, 03:53 AM
Post
#7
|
|
 Eats and sleeps DSM jargin. Group: Moderators Posts: 1,156 Joined: 23-September 02 Member No.: 16 |
I got hosed on my t-case when it locked up. I swore I'd show them and never buy a mitsu again. I bet they're still laughing at me.
-------------------- my cars breath smells like car food
|
|
|
|
|
May 10 2005, 04:26 AM
Post
#8
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
I'm not sure just heard that there was a difference
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 10 2005, 08:51 AM
Post
#9
|
|
|
DSM Tech Wizard Group: Members Posts: 2,404 Joined: 16-December 03 From: Fletcher/Bloomington Member No.: 214 |
I thought all the autos were 22 spline and my brain tells me the drive ratio (like the rear end ratio) should be different as well.
-------------------- "I hear he tunes the space shuttle also...and that thing is fast"
|
|
|
|
|
May 10 2005, 10:02 AM
Post
#10
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
I'm not positive, but I'm thinking the auto and manual T-case of the '91 and later should be the same. All drive ratio is done either in the transmission or the rear end, so I know that's not an issue. I think it was just the '90 T-cases, auto and manual alike, that were 22 spline.
|
|
|
|
|
May 10 2005, 11:25 AM
Post
#11
|
|
 DSMCentral Freak Group: Members Posts: 396 Joined: 10-January 01 From: Peoria, IL Member No.: 8 |
The center case section on the auto transfer case is different. I have taken the center section of the a broken manual transfer case to convert an auto to a manual case. I should have the auto center section somewhere if needed. As Nate said the gears ratio in the cases are all the same. I do know our old 91 red car came from the factory with a 22 spline case. The dealer installed a 23 spline case when they installed the 94 style tranny. I had 3 transfer cases fail before the recall ever exsisted.
-------------------- |
|
|
|
|
May 10 2005, 04:49 PM
Post
#12
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
ok I'm lost
 so if I buy a 92 5 speed TC will it fit in my 92 Auto ?
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 10 2005, 08:18 PM
Post
#13
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
I'm still looking for a trailer to move my car. anyone want to help me move it so I can start taring it apart?
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 11 2005, 02:48 PM
Post
#14
|
|
|
DSMCentral Freak Group: Members Posts: 396 Joined: 10-January 01 From: Peoria, IL Member No.: 8 |
QUOTE (mitsu90 @ May 10 2005, 10:49 PM) ok I'm lost so if I buy a 92 5 speed TC will it fit in my 92 Auto ?No it will not unless you put the auto center TC section on the manual TC. -------------------- |
|
|
|
|
May 14 2005, 12:05 AM
Post
#15
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
well my new TC should be here sometime next week. I am going to pick my car up Sat. and start taking it apart. I am done messing with the dealer can't get the same story twice from them, first is was full of fluid and not leaking, then a guy told me it was empty and his boss told him he wouldn't know he was on vacation when my car was inspected. then the manager took a look at it and told me that there was almost no fluid in it at all but it was not leaking so it would not be covered under the recall. this is the same guy that told me on monday that it was full of fluid.
 the best part is none of them can tell me were my fluid went the best I can guess it just evaporated. so with any luck my car will be back on the road by next weekend 
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 14 2005, 03:39 PM
Post
#16
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,754 Joined: 25-June 04 From: 61554 Member No.: 314 |
well went and picked my car up today get it home jack it up crawl under it and find this
-------------------- ┌∩┐(◣_◢)┌∩┐
|
|
|
|
|
May 14 2005, 04:05 PM
Post
#17
|
|
 Eats and sleeps DSM jargin. Group: Members Posts: 1,985 Joined: 30-June 03 From: Peoria, IL Member No.: 150 |
looks like a class 2 or 3 leak to me
-------------------- You CAN sleep in your car, but your CAN NOT race your house!!!
------------------------------------------------------- Double Decker spoilers are uber ricerlicious!!!!  |
|
|
|
|
May 16 2005, 09:36 AM
Post
#18
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
I used to see the same leak from my tc. This leak fix worked great for me.
http://www.vfaq.com/mods/transfer-print.html |
|
|
|
|
May 16 2005, 09:45 AM
Post
#19
|
|
 Eats and sleeps DSM jargin. Group: Members Posts: 1,995 Joined: 27-November 04 From: Yates City IL Member No.: 389 |
QUOTE (natedogg @ May 16 2005, 09:36 AM) I used to see the same leak from my tc. This leak fix worked great for me. http://www.vfaq.com/mods/transfer-print.html Did you do the RTV inside the yoke or the JB Kwik Weld outside the yoke method?? -------------------- 92 Eagle Talon TSI AWD "The Black Golfball" How fast can a 14B go???
91 Chevy C1500 "Problem Child" **SOLD** 01 Impala DD 07 Trailblazer Wife's new DD Cars run on blood, sweat, and horsepower... Without the first two, you can't get the last" SOB Racing "Sitting On Blocks" |
|
|
|
|
May 16 2005, 09:52 AM
Post
#20
|
|
|
Zen Master DSM Group: Moderators Posts: 3,008 Joined: 10-January 01 From: in front of you Member No.: 5 |
I used the JB weld method.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 10th October 2025 - 05:45 AM |
Powered By IP.Board
© 2025 IPS, Inc.