awd4me
Apr 28 2004, 10:42 PM
went out to check on the talon and thought i would try to fix the not going into reverse problem....i figured i could adjust the clutch cause i figured it just wasnt disengaging all the way.....when i sit in the car with it started, if i even move the shifter over towards first gear the car starts to roll forward...when i put it in first it starts grabbing about an inch away from fully pressed down.....i tried adjusting the master cylinder rod but adjusting it both ways made almost no improvement....and when you pop the cap off of the mastercylinder and press the clutch all the way down the fluid doesnt move....does that sound like the slave cylinder?
MidwestDSM
Apr 28 2004, 11:42 PM
not to me. From my experience with slave cylinder problems, the slave cylinder will simply go out and you cannot get any clutch pressure anymore, causing it to sit on the floor. It just sounds like you have an aftermarket clutch that grips like hell to me...
ICGerms
Apr 28 2004, 11:47 PM
I'm not sure what exactly the problem is? The car doesn't go into ONLY reverse? Is that with the car turned on or off? Does it go into any other gear? About the slave cylinder...if the o-ring is bad, I think it USUALLY leaks, but I don't know if you can tell just by looking at the slave cylinder if it's leaking or not. It seems to me that we had to remove the rubber boot to get a real good idea if the O-ring was leaking, though. I believe that slave cylinder rebuild "kits" are real cheap, though. You might just want to rebuild yours. And make sure you bleed it WELL.
natedogg
Apr 29 2004, 08:19 AM
I had a problem on my AWD where the clutch would still grab even when the pedal was to the floor. Turned out to be a bad master cylinder in my car. But like ICGerms said, you may just need to bleed the hydraulics. It could be the slave cylinder as well esp. if it shows any sign of leaking. The slave and master cylinders both are pretty cheap from advance auto. So you won't be losing an arm and a leg to replace them if bleeding the hydraulics doesn't help.
awdnot2
Apr 29 2004, 08:37 AM
Like I said before, the last time I saw that car the slave cylinder was bad. If you bleed the system it may work for a short time but if the slave cylinder has not been replaced go ahead and do it. The master cylinder would be good to do while your at it. As said earlier in the thread they're not going to cost you an arm and a leg.
awd4me
Apr 29 2004, 04:12 PM
thanks for the advice.....
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.