Ok, I'm in the midst of the redesign on the stainless header. Here's the big question though:
Anyone have a measurement of the actual size of their turbine inlet for a larger turbo? (Mitsu flange)
I know the stock measurements are 6cm and 7cm on paper but I've measured a couple of stock turbos and stock ex-maninfolds at a hair under 5.5cm. Obviously not a true 6cm opening.
I want to avoid just assuming the '7cm' gasket is exactly that. Most likely I'll just order one and match to it but I'm hoping to get a few people to chime in here with the sizes on their 16G's, BR580's, etc. so that I can look for consistency.
thanks!