ok guys, finally got the income tax check and starting to order like a mad man! Here is the setup I plan on running this year:

evo III 16g
FIC 650s
turboback exhaust (already own)
aem fuel rail (already own)
walbro 255 hp lph (already own)
blow thru setup w/ translator
intercooler piping 2.5" (already own)

Now my ? is there anything alse that should be done other then a front mount. Do I need to get cams, and if so which ones and were from?

This is going on a 6 bolt that ill be dropping in shortly.

Thanks,
Travis

the motor will be rebuilt and bored .20 over also.

also where can I get the equal length half shaft setup?

Cams can be used at your discretion. They are definitely a valuable upgrade, but it's up to you. I reccomend Crower Stage 2 or Stage 3 depending on how big you want to go. Don't forget to grab a set of Crower springs and retainers as well if that's what you want to do.

In my opinion, FMIC should come before cams. The stock IC just doesn't cut it to begin with.

www.car-part.com

How are you planning on controlling your fuel? You might wanna look into getting a DSMLink. That is unless you're hoping that the translator will do a good enough job.

I have an safc II and also will have translator. Also eprom ecu and going to have a chip burnt.