I stripped out one of the mounting bolts on my transmission. Was wondering if anyone happened to have a 1/2" or bigger tap that I could borrow to get this straightened out. Except for you, Rob. You'll probably put high explosive in the tap in an attempt to take my car out.

I've got a heli coil setup for m12x1.75 from doing my trans.

I'll throw it in the car and meet you tomorrow if you want it.

Joe, if I wanted to take your car out, I'd probably just use this Scud I bought on the cheap as Iraq was being invaded.....

I may have a tap, can't remember how big my set goes...

I have a tap.....fo yo ass!! I'ma tap dat ass!

Seriously though, if these guys can't get it up, I should have a tap that will work for you. I have a complete metric set and a bunch more that I have bought at one time or another.

Is that the size i need? For some reason I had it in my head that it was a 14, but that doesn't make sense, because a 1/2" tap certainly wouldn't work. Cool. Where can I meet you at tomorrow? Somewhere we can be alone, perhaps?

Nate: Why didn't you speak up sooner, pal? I'll gladly swing by and give you a good rogering for an hour or so. Oh, sorry. I guess I have to respect you 'cause you're going to be a father and all. My bad.

Rob: I heard your set goes plenty big, stud.

The stock thread is m12x1.25...I couldn't find that size so I went with what was available.

Soooo...you'll have to pick up a new bolt.

You'll need a 1/2" drill also for the drill bit.

Sent you a PM with my cell and a PRIVATE location....

The Master Of Tools needs not your proffering of a drill. He is more than equipped to handle tasks of varying sizes and shapes. Bits are of no concern, either. Muwhahahahaha....er..... god I'm dumb.