bburden86
Jun 16 2006, 12:45 AM
When i took of my intake manifold to replace a couple warn gaskets. i noticed i had some oil build up in my manifold. And it was more so in the farthest right port if your looking at the engine. also i think thats where my sticking or ticking whatever you guys said, with my lifter problem. but that where it sounds like that is coming from. any help????
AWD DSM 1
Jun 16 2006, 06:40 AM
Oil in the manifold is typical because the pcv valve and breather vent into the intake on a stock car.
doayamaha
Jun 16 2006, 03:29 PM
also depending on the amount of oil, turbo seal could be bad. but i would check the smaller things that awd mentioned first.
The Iron Goat
Jun 17 2006, 08:20 AM
Yes, the turbo oil seal going out would put oil in the intake, however I doubt that's what he's running into. It's just how the system is normally. The only answer is an oil catch can.
99Spyder
Jun 17 2006, 08:41 AM
I doubt that it is a turbo seal since he doesn't have one. He's running N/A.
bburden86
Jun 17 2006, 07:41 PM
right i don't have a turbo do you guys think i should replace the pcv valve or no
black92_tsi_awd
Jun 17 2006, 08:58 PM
Replacing the PCV valve will not keep oil out of your intake. The only way to keep the intake clean is plumbing the pcv valve and breather vent into a catch can as Goat suggested.
bburden86
Jun 17 2006, 11:40 PM
yeah i got that now, but would it do anything for my car. as far as performance or life of the car. or would it be smart to run with a catch can. and if so how do i make one and what do i use.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.