Well im ready to start on wiring the old truck up, but i have no clue what to do. i can solder wires together but looking at diagrams and stuff is not my cup of tea. I guess i just dont know what all is needed to be done and how exactly to run the wires.

Can anyone help me out. I have a bunch of diagrams if someone could maybe make ones that are easier to read or tell me what exactly needs to be done and what wires need to go where. I want to get this thing done. any help would be great.

And if you havnt read my project thread. im putting a 4g63t engine into my 87 dodge ram 50. Im using the dsm harness and ecu. so i was told i pretty much need to add power and ground to the harness and same for the new walbro in line fuel pump since the truck was carb. before.

Here are some of the wiring info. if someone could do a wiring for dummies for me. haha

here is my thread on the website about the swap. idk if this might be useful.
http://www.mightyd50.com/forum/showthread....ght=4g63+wiring

here is the clips and some more wiring info on another site. shows the pins and stuff.
http://www.projectzerog.com/wiring-how_to.shtml

Another that shows both clips and what they do.
http://www.projectzerog.com/wiring_info.shtml

and heres a diagram that a guy did but i cant understand a thing.
http://www.mightyd50.com/forum/showthread....ht=4g63t+wiring

if someone could help me out that would be sweet. idk if it possible to make it any easier hopefully it is.