 slave? |
 Apr 28 2004, 10:42 PM
Post
#1
|
|
 Person of Wisdom  Group: Members Posts: 142 Joined: 14-March 04 From: peoria Member No.: 258  |
went out to check on the talon and thought i would try to fix the not going into reverse problem....i figured i could adjust the clutch cause i figured it just wasnt disengaging all the way.....when i sit in the car with it started, if i even move the shifter over towards first gear the car starts to roll forward...when i put it in first it starts grabbing about an inch away from fully pressed down.....i tried adjusting the master cylinder rod but adjusting it both ways made almost no improvement....and when you pop the cap off of the mastercylinder and press the clutch all the way down the fluid doesnt move....does that sound like the slave cylinder?
-------------------- Stupid White Kid Racing
Run your car, not your mouth.... |
 |
 
|
 |
Replies
|
Apr 29 2004, 08:37 AM
Post
#2
|
|
 DSMCentral Freak Group: Members Posts: 396 Joined: 10-January 01 From: Peoria, IL Member No.: 8 |
Like I said before, the last time I saw that car the slave cylinder was bad. If you bleed the system it may work for a short time but if the slave cylinder has not been replaced go ahead and do it. The master cylinder would be good to do while your at it. As said earlier in the thread they're not going to cost you an arm and a leg.
-------------------- |
|
|
|
Posts in this topic
awd4me slave? Apr 28 2004, 10:42 PM
MidwestDSM not to me. From my experience with slave cylinder ... Apr 28 2004, 11:42 PM ICGerms I'm not sure what exactly the problem is? The... Apr 28 2004, 11:47 PM natedogg I had a problem on my AWD where the clutch would s... Apr 29 2004, 08:19 AM
awd4me thanks for the advice..... Apr 29 2004, 04:12 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 18th June 2026 - 06:11 AM |
Powered By IP.Board
© 2026 IPS, Inc.