 SAFC II install |
 May 25 2004, 10:27 AM
Post
#1
|
|
 DSMCentral Freak  Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21  |
Well Ive got myself an SAFC II but I dont know much about them. The install looks easy as pie, but my question is if I can hook it up then run the stock A\F ratios until I can get it tuned? Or do I have to put some sort of values in there to make it run right? TIA guys!
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
 |
 
|
 |
Replies
|
May 26 2004, 04:03 PM
Post
#2
|
|
|
DSMCentral Freak Group: Members Posts: 334 Joined: 29-September 02 Member No.: 21 |
Well this is going to sound dumb, but I took the sheathe off of the SAFC II harness and the RPM signal wire was cut in half. I patched it up and hooked it back to the wire that APEXi said to use, but now I only get half of the RPMs that my tach reads. Should I set it to 2cyl or just hook it back to the actual CAS (RPM) wire? Thanks again guys!
-------------------- 2003 Mustang GT
2008 Harley Nightster 1990 Mustang LX 5.0 notch |
|
|
|
Posts in this topic
mark95turbo SAFC II install May 25 2004, 10:27 AM
natedogg I'm pretty sure you can install it and run 0% ... May 25 2004, 10:58 AM ncgalant Yes, leave it at 0 until you can tune it. Zero is... May 25 2004, 11:04 AM mark95turbo Awesome! Thats what I figured, but I would ra... May 25 2004, 11:07 AM mark95turbo I read somewhere that you have to set it to a 2cyl... May 25 2004, 12:57 PM ncgalant no, go with 4. It works fine running off of the t... May 25 2004, 03:42 PM mark95turbo QUOTE (ncgalant @ May 25 2004, 09:42 PM)no, g... May 25 2004, 07:21 PM ncgalant the knock doesn't work on DSM knock sensors. ... May 25 2004, 09:38 PM mark95turbo QUOTE (ncgalant @ May 26 2004, 03:38 AM)the k... May 25 2004, 10:19 PM ncgalant thanks for the info. I guess that's why you w... May 25 2004, 10:33 PM mark95turbo Troy. What pinout did you tap your RPM (green wir... May 26 2004, 02:29 PM
 |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 16th June 2026 - 09:04 AM |
Powered By IP.Board
© 2026 IPS, Inc.