 Project POS Progress |
 May 2 2003, 09:52 PM
Post
#1
|
|
|
DSM Tech Wizard  Group: Members Posts: 2,256 Joined: 10-January 01 From: central IL Member No.: 10  |
Motor is IN!
 Tranny tomorrow am (hopefully). Anybody know the best place to get tranny seals? I've tried Autozone, Advance, and NAPA. Closest I got was the two outputs for the transmission from NAPA. Guess I'll try satan tomorrow. 
-------------------- The fastest car I own is a minivan....
|
 |
 
|
 |
Replies
|
May 7 2003, 08:07 PM
Post
#2
|
|
|
DSM Tech Wizard Group: Members Posts: 2,256 Joined: 10-January 01 From: central IL Member No.: 10 |
Brain Buster of the day....
When the key is turned to the "on" position or motor is turned over, the fuel pump does not turn on as it should. When connected directly to 12v, pump turns on. When relay (from rewire) signal terminal is connected to 12v, pump comes on. I checked over the phone with Darryl on a couple other things... ECU seems ok, and MIP? unit is ok (one on pass side in the center console by the ECU). As far as I know all wiring is hooked up correctly, and no fuses are blown. Any ideas why I'm not getting fuel? Fuel filter is brand new and yes it's installed in the right direction.  At one point, I had fuel comming out of the top of the filter becasue of a loose connection, which has since been fixed. I have checked spark.Anyone? There's a special spot for your name on my garage wall if you figure this one out!! 
-------------------- The fastest car I own is a minivan....
|
|
|
|
Posts in this topic
AWD DSM 1 Project POS Progress May 2 2003, 09:52 PM
KOU In3 Congrats on dropping that motor in. Must feel gre... May 3 2003, 12:39 AM wortdog The dealer is the only place I've ever been ab... May 3 2003, 01:28 AM AWD DSM 1 Thanks Travis, I hope to have some pics later toda... May 3 2003, 06:34 AM akamiami I got mine from Advance Auto. Take a used one to ... May 3 2003, 10:24 AM wortdog Hmm, Advance Auto could only find two of the seals... May 3 2003, 11:30 AM AWD DSM 1 Tranny's in... Now I get to take it back out... May 3 2003, 05:07 PM AWD DSM 1 Tranny out and back in in less than an hour.... b... May 3 2003, 07:31 PM AWD DSM 1 Mounts swaped out. Axles are in. Few other misc ... May 4 2003, 11:52 AM AWD DSM 1 So, so close... but yet not close enough. Still ... May 6 2003, 10:08 PM AWD DSM 1 Car is complete. Everything is in place. Whether... May 7 2003, 03:28 PM AWD DSM 1 HHHHHHHHHEEEEEEEEEEEEEEEEEEEEELLLLLLLLLLLLLLLLLLLL... May 7 2003, 04:15 PM wortdog Just wire it to a switch and be done with it May 8 2003, 02:57 AM AWD DSM 1 Fuse seems to be ok. Forgot to mention that when ... May 8 2003, 08:42 AM JBone Could the relay be bad? May 8 2003, 09:01 AM AWD DSM 1 I wish I had some extra stuff to swap in and try. ... May 8 2003, 09:25 AM Turbo Tension Just hotwire that bitch to the battery! May 8 2003, 09:27 AM Mike QUOTE (Turbo Tension @ May 8 2003, 10:27 AM)J... May 8 2003, 05:57 PM AWD DSM 1 While directly wiring the pump to the battery or i... May 9 2003, 06:50 AM AWD DSM 1 Well, the POS ran tonight... for about 5 min.
... May 12 2003, 09:14 PM KOU In3 I'm thinking about heading out to P-town again... May 13 2003, 01:26 AM natedogg I think Josh might have an extra fuel pressure gua... May 13 2003, 08:13 AM AWD DSM 1 heh, I don't think it's lack of desire... ... May 13 2003, 09:10 AM
AWD DSM 1 Well.... I gave in. Car will be heading to Slo P... May 13 2003, 11:38 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 21st October 2025 - 04:52 PM |
Powered By IP.Board
© 2025 IPS, Inc.