 Clearance checking? |
 Mar 3 2006, 11:39 AM
Post
#1
|
|
 Eats and sleeps DSM jargin.  Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636  |
I have a question about the main and rod clearances.
1. I went to the zone and got some plastigauge to do this. They gave me the green colored one. Is this right, all the measure ment are no where near what I seen in the book. 2. Are there any tips I should know before performing this task. I have read my chiltons about this. I just wanted to know if someoen had something to add. 
-------------------- Thanks, Bud!
 |
 |
 
|
 |
Replies
|
Mar 3 2006, 11:48 AM
Post
#2
|
|
|
Eats and sleeps DSM jargin. Group: Members Posts: 1,108 Joined: 2-October 05 From: Waverly, Illinois Member No.: 636 |
The book says 0.0008 to 0.0020 now the plactigauges measurements are .001, .0015, .002, & .003 !
I haven't performed the hole test yet. This is because I was unsure of the measurements between the two. And a little lazyness. 
-------------------- Thanks, Bud!
|
|
|
|
Posts in this topic
BudmannG Clearance checking? Mar 3 2006, 11:39 AM
AWD DSM 1 I'm pretty sure the green is what I used. wha... Mar 3 2006, 11:42 AM AWD DSM 1 You got the right stuff. As long as the plastigau... Mar 3 2006, 12:03 PM
BudmannG Thanks Man ! Mar 3 2006, 12:22 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 24th September 2026 - 09:58 AM |
Powered By IP.Board
© 2026 IPS, Inc.