Project 94 AWD Options

[93dsmowner]

The goal is simple. All around awesomeness.

I took the car to the track for the Hangover Fest and managed a 11.95 @ 115.86 mph. Car is setup as follows.

Stock 7 bolt with ARP head studs.
Big 16g I rebuilt
Punishment FMIC
3" exhaust, stock o2 housing.
2g exhaust manifold
FIC BlueMax 1250 injectors
Jay Racing 341 intank pump (270lph at 70psi operating pressure)
KYB AGX Struts/Ground Control coilover sleeves

Putting on the Jay Racing Toe Eliminator soon.

11.95 at around 27psi of boost.

Trying to figure out where I want to take it next..

[awd4kicks]

Sounds good!

Mine is a stage 3 Buscher short block built with 272's and all the tricks. It is supposed to hit full boost long before it does. I think my main problem is my stock, but ported 2G exhaust manifold and my smart but limited street tune on a stock EPROM. A header and a real management system would make it sick. Unfortunately traction is already rediculous at these power levels. Even with AWD I normally can only pull a 1.9 60ft. on the Sumitomos that I have. When I had the 14b at around 375-400hp I was easily cutting low 1.7 second 60 ft. times. So mine will need stickier tires (maybe slicks) to bring the quarter mile times back in line with it's potential. Then of course heavier duty axles will probably be required as they begin to snap under the new level of grip. After 10 years of pouring money, heart and soul into my Talon I am on a much needed break. Stay tuned... Although these are some things to anticipate as you build your project.

Good luck and keep up the good work.