 Ex-man/turbine inlet measurements |
  |
 Jun 17 2004, 02:38 PM
Post
#1
|
|
 Post Master  Group: Members Posts: 972 Joined: 30-October 02 Member No.: 34  |
Ok, I'm in the midst of the redesign on the stainless header. Here's the big question though:
Anyone have a measurement of the actual size of their turbine inlet for a larger turbo? (Mitsu flange) I know the stock measurements are 6cm and 7cm on paper but I've measured a couple of stock turbos and stock ex-maninfolds at a hair under 5.5cm. Obviously not a true 6cm opening. I want to avoid just assuming the '7cm' gasket is exactly that. Most likely I'll just order one and match to it but I'm hoping to get a few people to chime in here with the sizes on their 16G's, BR580's, etc. so that I can look for consistency. thanks! -------------------- |
 |
 
|
|
Jun 17 2004, 02:53 PM
Post
#2
|
|
 Eats and sleeps DSM jargin. Group: Members Posts: 1,035 Joined: 31-March 04 From: Chambana Member No.: 268 |
small 16g right at 6, 14b right at 5.4
-------------------- game over.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 15th March 2026 - 05:24 AM |
Powered By IP.Board
© 2026 IPS, Inc.