 Project: The TSI AWD that could. |
  |
 May 10 2008, 10:22 PM
Post
#41
|
|
 DSMCentral Freak  Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799  |
Ok then. It was milky and there were small shavings on the drain plug so my tranny needs built for sure.
-------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
 |
 
|
|
May 11 2008, 12:22 PM
Post
#42
|
|
 Post Master Group: Members Posts: 864 Joined: 12-July 05 From: Illinois Member No.: 556 |
oh for sure!!!!
-------------------- "One of the most Crazy and Undecisive Members in central Illinois"
|
|
|
|
|
May 11 2008, 09:41 PM
Post
#43
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
So today I:
Cleaned the K&N Filter and reoiled it Pulled lower honeycomb on MAS. Swapped front wheels. Back wheels need a sledge to come off... Reinstalled balance shaft belt I should hopefully have the money for my tranny by the end of June. I think I may just save until Spring and build it then. I figure I should have $5k saved by Spring if I'm lucky. -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 12 2008, 05:45 AM
Post
#44
|
|
|
Post Master Group: Members Posts: 864 Joined: 12-July 05 From: Illinois Member No.: 556 |
Ok i think we've had enough talk about the tranny...........
why did you take the balance shaft belt off? actually you never said you were even doing a timing job! -------------------- "One of the most Crazy and Undecisive Members in central Illinois"
|
|
|
|
|
May 12 2008, 06:26 AM
Post
#45
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Timing belt was fine. Balance shaft belt fell off when I revved to like 5500 so I replaced the belt.
-------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 19 2008, 10:03 PM
Post
#46
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
UPDATE:
Went to go about putting in my head unit and new speakers and found out that I'm missing my passenger side window motor! Heh. Window was being held with a toilet plunger and vice grips. So here's my list so far of needs. Valve cover Carpet for hatch window motor (Getting all for $80) Tranny rebuild (Emailed Jacks about the $800 Economy build) Underbody cleaning. Also, pulled the heat shield off my cat the other day. Much less annoying rattle. Have to find the remainder, but it was enough that I could hear my BOV in the car. I revved it to 6k once and it makes a whirring sound I never heard before. It sounds normal, and it was after I ran SeaFoam through it. Think it's just from the carbon buildup coming off? I'm going to do an oil change again soon, since I start it everyday and play with it. Another couple tard questions. 1. When I turn the key to on before I start it, there's a bubbling sort of noise and if I let it do it for a couple minutes it stops. What and why? I can't locate the sound but it's in the engine bay. 2. Why does it take so long to start? I swapped batteries with my Eclipse and it's the same problem. Takes 3 or 4 seconds of cranking instead of instant like my Eclipse. Normal or what should I do to fix it? Sorry guys. I'm anal. Not sure if that's good or bad when owning a DSM.. -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 19 2008, 10:29 PM
Post
#47
|
|
|
Post Master Group: Members Posts: 864 Joined: 12-July 05 From: Illinois Member No.: 556 |
1- its not a bubbling noise your hearing its a relay on the fire wall. cant remember which one is the culprit but thats where the noise is coming from.
2- most likely its the coolant temp sensor. they cause the cars to run a little rich when the fail and that causes it to have a rough start. Plus the light was on which means its prolly a junk sensor. -------------------- "One of the most Crazy and Undecisive Members in central Illinois"
|
|
|
|
|
May 20 2008, 05:54 AM
Post
#48
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
I filled the overflow res and topped off the system and the light is gone...
I'll look into replacing the coolant temp sensor. Would the temp gauge still work properly? -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 20 2008, 06:21 AM
Post
#49
|
|
 Post Master Group: Members Posts: 774 Joined: 28-October 02 From: Pekin Member No.: 32 |
It would probably work more accurately.
-------------------- 2009 Scion Tc
1994 Del Sol Si 1991 Talon TSi AWD 1990 Mustang GT FOR SALE!!! |
|
|
|
|
May 20 2008, 08:21 AM
Post
#50
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
I meant would it work right even if the temp sensor was bad.
-------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 20 2008, 03:56 PM
Post
#51
|
|
 Post Master Group: Members Posts: 908 Joined: 7-October 03 From: Chillicothe, IL Member No.: 182 |
The dash guage and ECU use different sensors that are right next eachother. On the Tstat housing, the one with one wire is your guage, and the two wire goes to the ECU
-------------------- GVR4 866/1000 = the perpetually broken car
|
|
|
|
|
May 20 2008, 06:02 PM
Post
#52
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Well, I'll look into it soon.
-------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 21 2008, 10:51 PM
Post
#53
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
So it's not my shifter that is the problem. The cable itself is tight...
What do I need to do? I can't see crap as far as binding goes under the car or anything. Going to get SS clutch and brake lines after the car is driveable (Read: New tranny and t-case) -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 22 2008, 12:17 AM
Post
#54
|
|
 Person of Wisdom Group: Members Posts: 217 Joined: 30-June 07 From: Pekin IL Member No.: 1,184 |
So do you still have the 1.8L eclipse?
-------------------- Dakota D.|1995 Mitsu Eclipse GST
It's stock... |
|
|
|
|
May 22 2008, 06:03 AM
Post
#55
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Yeah. It's for sale. $2500 OBO.
-------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 24 2008, 09:04 AM
Post
#56
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Yeehaw!
Picked up the Punishment Racing intercooler from Travis along with other tidbits (Lights, mbc, valve cover, window motor, etc.) Pulled the entire intake from the turbo back out. I just need to figure out how to get the intercooler on. My buddy and I went to bolt the bottom brackets to the bottom and the bolt head broke off  I think we must have broken 20 bolt heads last night. Ugh. Oh well, I just have to take an Easy Out and have at it... -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
May 26 2008, 09:40 PM
Post
#57
|
|
|
Post Master Group: Members Posts: 864 Joined: 12-July 05 From: Illinois Member No.: 556 |
so did u figure everything out?
-------------------- "One of the most Crazy and Undecisive Members in central Illinois"
|
|
|
|
|
May 27 2008, 05:50 AM
Post
#58
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Getting closer. I quit around 11:30. Worked at my dad's friend's house yesteray. Made $100.
I'll be done sooner or later. -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
Jun 3 2008, 10:55 AM
Post
#59
|
|
|
Person of Wisdom Group: Members Posts: 217 Joined: 30-June 07 From: Pekin IL Member No.: 1,184 |
update?
-------------------- Dakota D.|1995 Mitsu Eclipse GST
It's stock... |
|
|
|
|
Jun 3 2008, 01:46 PM
Post
#60
|
|
|
DSMCentral Freak Group: Members Posts: 355 Joined: 18-March 08 From: Washington, Illinois Member No.: 2,799 |
Nah. It's been set to the backburner. I had finals this week (Fri, Mon, Tue) and now I'm in the process of putting my audio setup in the Cavalier.
I need a new harness that plugs directly into the HU. Mine's buggered, and I can't find one as of yet. :/ -------------------- If the sound of a DSM in the distance rowing through the gears gives you a hardon, you might be a car enthusiast.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 6th August 2026 - 08:54 AM |
Powered By IP.Board
© 2026 IPS, Inc.