I have installed everything, yes it is done correctly b4 you ask. and yes I am competent too. The only signal I have going to the afc is the damn knock signal, during initial set up I was doing the normal set up and I could not get any voltage readings from my TPS? I have a 2G eagle talon TSI AWD I am not sure if my TPS is bad or what any ideas??

If you have a haynes or a chiltons, they outline a procedure to check if your TPS is bad. Basically just checking resistances. If you can get a logger on it, you could check it that way too.

They also have info on vfaq.com for the same thing. Just a little better detailed.
I would also go over all the wires just to make sure. It is always nice to double check things that you know you did right. That way you know you did do it right. I myself think it is hooked up to the wrong wire. I have done this myself, So I know now to double check everything.

Not trying to knock you or anything, but did you use butt connectors, or soder. The reason I ask is becuase I have had that problem B4 and it was because I didn't soder all of my connetions.

Ok thanks everyone but it is done.. ok next question who knows what they are doing as far as tuning this thing lol I have been reading everything I can find on it I have been playing with this and wow I get some major snap neck but it is falling on its face when I let off the gas to either shift or when I give it thtl it stutters then kicks in ? obviously I got allot to learn on this area anyone in the Peoria area willing to help or what ever? thanks guys later.