 TypeS BOV Problems, Looking for Ideas here |
 Jun 16 2004, 08:01 PM
Post
#1
|
|
 Beginner  Group: Members Posts: 40 Joined: 9-January 04 From: Peoria Member No.: 223  |
 I just installed a total 3" Turbo back exst and Hard Pipe and Electronic 2 stage boost controller,, Now all is kinda good but my BOV is not working properly. When It is supposed to dump air My turbo sounds like it has some pissed off squirrels caught in it. when I put the stock upper pipe and stock BOV back on all is ok cept I have $250 worth of paper waits, it may be just a worn out turbo but when I bought the car it had the greddy hard pipe and Type S on it and everything worked well. Any Ideas would be helpful.  Thanks Don.
|
 |
 
|
 |
Replies
|
Jun 17 2004, 06:30 AM
Post
#2
|
|
 Post Master Group: Members Posts: 972 Joined: 30-October 02 Member No.: 34 |
Have you tried adjusting the aftermarket one? If it is adjusted so that the spring is too tight or has a spring rated for higher boost it can act funny on low boost settings.
For instance: I've noticed using a Tial on low boost settings can give some pretty serious compressor surge on a small turbo. Hope that helps a bit. -------------------- |
|
|
|
Posts in this topic
justooln2 TypeS BOV Problems Jun 16 2004, 08:01 PM
SCCA Stang according to a previous thread the stock BOV is mo... Jun 16 2004, 10:52 PM SCCA Stang here is the link to the thread I posted a while ba... Jun 16 2004, 10:55 PM xian 1g 1 gen or 2g? Jun 17 2004, 01:34 AM
 |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 14th March 2026 - 10:52 PM |
Powered By IP.Board
© 2026 IPS, Inc.